TitanX Instructions

HWID Woofer

HWID Tool — Setup Guide & Best Practices

Prerequisites

Before launching the loader, make sure the following are disabled on your system:

Use the checker below to verify all items are properly disabled.

Disable VPN before use

Turn off any VPN, proxy, or network filter before running the HWID checker. Active VPN may cause incorrect or failed results.

1Launch the loader and enter your key.

2If you had a previous session or need a fresh start:

a)Restart your router to get a new IP (dynamic IP required).

b)Click Clean in the loader to wipe the previous session.

c)Click Reload PC and wait for the system to restart.

3If any security feature was not disabled manually, click Security Off → Reload PC.

4Launch HWID Identity Changer and wait for the driver to fully load.

5Close the application. Done.

If you are using third-party software, launch it first, then repeat Option A from the beginning.

Run the Checker Before Launch

All red items in the checker must be fixed before proceeding:

You can download Defender Control from the internet to easily toggle Defender:

Reboot your PC and launch the loader right after the system starts.

Having issues? Check solutions or open a support ticket in our Discord community:

The loader requires the following official Microsoft runtimes to be installed:

Sync time and date

Go to Windows Date & Time settings and click "Sync now".

Key input field not showing

Re-download the loader to a different folder and temporarily connect via VPN.

Windows — Application error

Ensure all runtimes are installed, reboot PC, or try using a VPN during initial connection.